Clear Engine Codes

Discussion in 'Indian Motorcycle General Discussion' started by JayFL459, Apr 20, 2019.

  1. JayFL459

    JayFL459 Silver Member
    Original 111

    Joined:
    Aug 5, 2016
    Messages:
    3,938
    Likes Received:
    9,621
    Trophy Points:
    3,193
    Location:
    Lake City, FL
    Reset Error/Trouble Codes
    Ignition Key (IK) OFF
    Kill Switch (KS) OFF
    Turn IK ON
    Turn KS ON
    Fuel pump will cycle
    Turn KS OFF
    Turn IK OFF
    Wait 10 seconds
    Repeat sequence another three (3) times ...... That’s four (4) times in total.
    At the fourth (4th) time, start the bike after the fuel pump has cycled.
    Run the engine for 30 seconds, then shut down normally.
    Most (if not all) codes should have cleared to the historic mem
    ory.



    Just added this because I know it works and lost it in my files, Now have access .. If have a Start Button just consider that where says Ignition Key .. Have used this on my Scout and Chieftain Both and it works ..
     
    Alpal, theMucker, Warlock and 4 others like this.
  2. Alpal

    Alpal Gold Member
    Supporter Original 111

    Joined:
    Aug 5, 2016
    Messages:
    13,745
    Likes Received:
    27,775
    Trophy Points:
    8,193
    Location:
    Burtland (New Zealand)
    Thats brilliant Jay,....Ive printed that off and its going in my workshop manual,.....
     
    JayFL459 and Warlock like this.

Share This Page